Beaufort Gyre Exploration Project | Cruise

By Will Ostrom

Mooring Day
We expected to be at the Beaufort Slope (BS-3) mooring location (approximately 71.4 °N, 152 °W) before breakfast, but heavy ice conditions has impeded our path and slowed the ship considerably. So after breakfast, the Captain decided that a helicopter flight was needed to survey the ice conditions at the mooring site, in order to determine whether a recovery would even be feasible. Chris Swannell (helicopter pilot), Scott Payment (ice observer), Sarah Zimmermann (Chief Scientist) and Rick Krishfield (WHOI) flew to the site and discovered that the ice was much less concentrated and broken up than the ice that the Louis was presently mired in. That was very good news for our mooring team who were anxious to recover the sub-surface mooring for WHOI Scientist Robert Pickart.

In seawater only 147 m (480 ft) deep, the mooring's mechanical design consisted simply of a large floatation sphere at the top, an 85 m (280 ft) long length of wire rope, several glass flotation spheres, and an acoustic release attached to a large anchor. Attached to the top of the sphere was a profiling winch system to measure the seawater properties above the sphere, and a sonar instrument which determined the thickness of the ice drifting overhead. Oceanographic instrumentation attached to the mooring measured ocean temperatures, salinities, currents and direction over the previous year, and sea level variations from bottom pressure measurements. All this data was recorded internally, so it was necessary to recover the mooring to obtain the results. To read about the scientific objectives of the Beaufort Slope project visit the Arctic Edge website.

At noontime we arrived at the site. The ship's position relative to where the mooring would surface was critical. The desire was to have it come up approximately 20 m (65 ft) off the ship's starboard bow. With excellent ship handling from Captain Andrew McNeill on the bridge, the mooring came up just where it was expected. The mooring's bottom end with several 17" glass flotation spheres soon arrived on the surface. The ship then maneuvered alongside the large sphere and hooked it with the crane. The sphere was un-shackled from the mooring wire and stowed on deck. The Lebus winch was then brought into play, winding up the wire rope through a block hung in the A-frame. The scientific instruments on the wire were removed, and the remainder of the mooring was recovered with the ship's crane. The deck operations were completed in only 35 minutes from start to finish, and then it was time to open the instruments and see what information was collected for the past year.